You have now purchased your gutters, downpipes and fittings. Removed your old system (if you haven't removed it refer to article How To Remove Old Gutters and Downpipes). Prepared your guides, gathered your tools and you are now ready to start fitting your new system.

Ensure ladders are placed on a level surface and secured. All fittings should be secured using rustproof screws.

Fitting the first outlet

  1. Attach the outlet to the fascia using the string as a guide.
  2. Next, attach a bracket 100mm in from the end or corner, allowing space for the last fitting.
  3. Attach further gutter brackets at regular intervals, not more than 1 metre apart, make sure they are not fitted at any join points.

Fitting the gutters

  1. Beginning at the outlet, place the first length of gutter on the brackets. Position it so that the end is about 5mm from the stop end inside the outlet.
  2. Manoeuvre the back edge of the gutter under the clips at the back of the brackets. Carefully pull the front edge down into the front clips.
  3. Attach a jointing piece at the end and continue along the facia. Make sure you always allow 5mm clearance from the gutter stop within the fittings; this is to allow for expansion.
  4. Your last length of gutter will need to be cut to fit. This is easy to do with a hacksaw. Sand or file off any rough edges. This length will either fit into a corner piece or a stop end. If using a stop end, allow the gutter to extend past the end of the fascia by about 40mm.

Fitting the downpipes

  1. At each outlet, attach an offset bend pointing towards the wall. Position a second offset bend slightly off the wall ensuring it will line up with the downpipe which will be fitted using brackets.
  2. Measure and cut a length of pipe so as to connect the two offset bends.
  3. Holding a length of downpipe onto the bottom offset, place a pipe bracket over it to secure.
  4. Using chalk or a pencil, mark the screw positions for attaching the brackets to the wall; drill and plug the wall.
  5. Fit the bracket and secure the first section of pipe.
  6. Repeat the process at 2m intervals adding new sections of downpipe if necessary.

Drainage Points

  1. At the drainage point, the pipe will need to be cut to size, use a hacksaw and sand or file, as before.
  2. If the downpipe is to be fitted into an underground drainage point, ensure it is long enough to fit into the drainage housing.
  3. If the downpipe feeds into an open drain, cut it 50mm above the drain, and attach an outlet shoe.
  4. Repeat the process for each of the outlets.

You have now installed your new system! To ensure optimum drainage, regularly clear gutters and outlets of leaves and debris.

Another job well done and without the expense of employing the professionals!